Splash Gordon's Pool & Supply

Your local Source for all your Pool and Spa Needs

Available 1 H.P. and 2 ½ H.P., 120 or 240 volt Commercial Blowers can last a long time when properly installed. We like to put them on a shelf up off the floor about 48". If you have to leave them on the floor, there should be a 48" loop before the blower. The trick is to keep water out of the blower. We also recommend you install a swing check valve in line. The intake line should be as high up as possible and angled over, so debris can’t enter the blower.

Residential Blowers are not warranted when used in commercial locations. Residential Blowers should never be glued on their PVC pipe. We always recommend using a swing check valve and a 48" loop when installing close to spa level.
“METAL MUSHROOM” Available 1 H.P., 1 ½ H.P., 2 H.P., 120 or 240 volt	“QT” same motor as Metal Mushroom, but a larger plastic padded housing to make it “quieter”	Motor Kits are available in all H.P. and voltage. Brush replacement is a common repair on these blowers.

LEN GORDON AIR SWITCHES
These allow the off and on control of a water pump or air blower from a remote location without the use of electricity (a good thing around water). An air button is connected to a small tube (up to 100’) that is also connected to the control box. The control box switches the equipment on and off. The “A.S.T.D. combo” switch allows the air blower to come on for 10 minutes then shuts off. Replacement buttons are available for fiberglass spas or wood decks (threaded) or for cement decks (smooth).